Test and Install:

What I did next was test the unit for functionality, connecting the overhead right to the PAC, and just hanging it in place to make sure it works:


Hard to tell from the video, but the slider works perfectly. I can smoothly adjust the volume of the sub from zero to almost full gain, which is set by the gain on the amplifier.
http://www.youtube.com/watch?v=tIWdExBFlxQ

So now I know the unit works, I pulled out the headliner and measured out for a wiring harness. My headliner did not survive the trip:


Here's the wiring harness that will run from the overhead console to the PAC unit in the rear:

Overhead in place:

PAC in place, just needing the RCA cables redone and general tidying up:


And that is just about it. I can now control my aftermarket amp and subwoofer using the factory Performance Sound overhead control.

Only registered users can write comments.
Please login or register.

Powered by AkoComment 2.0!